karmynsbeep

Customer service like that is why I'll be ordering one soon!

scooby snacks

Now that's customer support!! Thanks PSC. I hope to install mine this weekend... I've had the thing since the beginning of December... heck I have the body armor I need to install as well. I hate working in the cold... lol

46chevytruck

No bulge in mine either.

scafootballpro5

I guess I'll just have to try tightening. In a different combo..

scafootballpro5

Well I took the louver off, re drilled the hole some size bigger and painted a layer of plasti dip on the hood so it's not metal on metal. It turns out it isn't a bulge in the hood louver..but the sheet metal underneath is indented a little bit. So, looks like I'll be using the pop rivets mentioned earlier in this post. Here's a pic of the plasti dip for protection.

DTS

Hey instead of pop rivets, why not placing a pair of the same stainless button head cap screws on either side of the washer nozzle? Drill right through both the hood louver and the hood, and draw them together with the hardware. Same idea as the pop rivets but it would match the existing hardware and look "factory". You can check the instruction sheet for the exact size when you go to the hardware store. If you can't find them locally we can send you a couple. I'm not at the shop this week I'm out at KOH, but if you call there someone can help you.

scafootballpro5

I did consider that but liked the pop rivet idea better because it matches the black around there. I feel like the 2 stainless would've looked out of place. I have the pop rivet on now and just need to get a picture!

scafootballpro5

Here's the final result.

karmynsbeep

Looks great glad it worked out for you!!!

LoneWolf

Glad you got it straight. I, too, installed one to cover hail damage that was present when I bought the Jeep, but I didn't have an issue.

Sent via Jeep wave from my NSA-approved domestic espionage device