Trailer build from scratch!
#62
JK Super Freak
Thread Starter
Join Date: Sep 2010
Location: Maine
Posts: 1,937
Likes: 0
Received 0 Likes
on
0 Posts
Thank you. My ultimate goal is to make a metal lid and then a roof top tent. My funds currently prevent aything like that. For the time being, I will have it covered by a tonneau cover that I am picking up tonight.
#64
JK Super Freak
Thread Starter
Join Date: Sep 2010
Location: Maine
Posts: 1,937
Likes: 0
Received 0 Likes
on
0 Posts
I picked up my cover tonight but wasn't able to put it on the trailer. I was working on the Jeep. I think I have a stuck rear caliper.
#67
JK Super Freak
Thread Starter
Join Date: Sep 2010
Location: Maine
Posts: 1,937
Likes: 0
Received 0 Likes
on
0 Posts
#68
JK Super Freak
Thread Starter
Join Date: Sep 2010
Location: Maine
Posts: 1,937
Likes: 0
Received 0 Likes
on
0 Posts
Had some time this morning so I decided to chop the fenders. I cut them 3 1/2 inches and gained over 2" in tire clearance to the fender!
Below shows the right side cut 3 1/2 " and the left not cut yet.
I gained over 2" of clearance from tire to inner fender. The rolled edge of the fender makes it look closer than it is.
Below shows the right side cut 3 1/2 " and the left not cut yet.
I gained over 2" of clearance from tire to inner fender. The rolled edge of the fender makes it look closer than it is.
#69
JK Super Freak
Thread Starter
Join Date: Sep 2010
Location: Maine
Posts: 1,937
Likes: 0
Received 0 Likes
on
0 Posts