Flush mount 4-pin trailer hitch connector
#1
JK Enthusiast
Thread Starter
Join Date: Jul 2007
Location: San Francisco, California
Posts: 219
Likes: 0
Received 0 Likes
on
0 Posts
Flush mount 4-pin trailer hitch connector
Does anyone know of a 4-pin version of the hitch wiring connector (see picture below) that I could flush mount into the bumper. I don't need a 7-pin and the 4 pin would actually be more useful so I was hoping to do something like the one shown below without going to a 7-pin.
Thanks,
Steve
Thanks,
Steve
#3
JK Enthusiast
Thread Starter
Join Date: Jul 2007
Location: San Francisco, California
Posts: 219
Likes: 0
Received 0 Likes
on
0 Posts
Thanks. I really need it to be compatible with the regular flat four (like all the light u-Hauls trailors have). Currently I have a factory wiring harness attached under the bumper but would like to move it up and out of the way of rocks. The closest I can come to what I want is to convert to a factory 7 pin harness and then use it to wire into the dual flush mount 4-pin/7-pin that these guys market.
hxxp://www.etrailer.com/Custom-Fit-Vehicle-Wiring/Hopkins/N40975.html?feed=npn
I'll do that if I have to (and if it's possible) but I don't really need the 7-pin so was hoping someone might know of a clean flush mount 4-pin connector.
Steve
hxxp://www.etrailer.com/Custom-Fit-Vehicle-Wiring/Hopkins/N40975.html?feed=npn
I'll do that if I have to (and if it's possible) but I don't really need the 7-pin so was hoping someone might know of a clean flush mount 4-pin connector.
Steve
Last edited by Steve Young; 03-03-2011 at 05:24 PM.