axles
#1
JK Enthusiast
Thread Starter
Join Date: Sep 2011
Location: USA
Posts: 429
Likes: 0
Received 0 Likes
on
0 Posts
axles
This may be a stupid question but would a dana 44 front and rear axle of a rubicon with e-loackers fit my 2007 sahara? Its an automatic of that matters at all
#4
JK Jedi Master
Join Date: Jan 2008
Location: Austin <--> Colorado Springs
Posts: 11,465
Likes: 0
Received 162 Likes
on
154 Posts
Same dimensions and all of the same brackets. The rubi axles will be direct bolt-ups for your sahara.
Do some research on aftermarket axles before you drop your load. Depending on the deal you get, buying a used rubi axle plus adding all of the strength upgrades could easily cost more than a pr44.
Do some research on aftermarket axles before you drop your load. Depending on the deal you get, buying a used rubi axle plus adding all of the strength upgrades could easily cost more than a pr44.
Last edited by nthinuf; 11-09-2011 at 09:43 PM.
#5
JK Enthusiast
Thread Starter
Join Date: Sep 2011
Location: USA
Posts: 429
Likes: 0
Received 0 Likes
on
0 Posts
#6
JK Enthusiast
Thread Starter
Join Date: Sep 2011
Location: USA
Posts: 429
Likes: 0
Received 0 Likes
on
0 Posts
I have all factory so would have to do a lot of upgrading to them too. Is it just cheeper in the end to go PR44 from the start?