Rock Krawler KOH 2014 Build Under Way
12-05-2013, 07:16 AM
#1
Former Vendor
Thread Starter
Rock Krawler KOH 2014 Build Under Way
We know this forum is all about JK's, but many of you have asked us to share our builds with you! Our KOH rig for 2014 to test our Bypass Shocks is an LJ.
The vehicle was tore down to the bare bones!
Fully mocked up only to be tore down again and sent to paint!
The axle housings were fully welded and powder coated here in house!
Now we are just waiting on the rig to come back from paint to start the final assembly! [Hopefully this Friday - Fingers Crossed]
Follow along for more exciting photos as the rig comes together!
One thing to note; we are using all of our products for this build. Our shocks, our control arms, our joints, our standard mounting brackets. Everything you could by right from us for your vehicle. We are putting our money where our mouth is just like we did on our Victim Build.
The chassis and components are all back from paint! This rig is going to look sick for sure… It had better perform as good as it is going to look!
RK
The vehicle was tore down to the bare bones!
Fully mocked up only to be tore down again and sent to paint!
The axle housings were fully welded and powder coated here in house!
Now we are just waiting on the rig to come back from paint to start the final assembly! [Hopefully this Friday - Fingers Crossed]
Follow along for more exciting photos as the rig comes together!
One thing to note; we are using all of our products for this build. Our shocks, our control arms, our joints, our standard mounting brackets. Everything you could by right from us for your vehicle. We are putting our money where our mouth is just like we did on our Victim Build.
The chassis and components are all back from paint! This rig is going to look sick for sure… It had better perform as good as it is going to look!
RK
12-05-2013, 07:17 AM
#2
Former Vendor
Thread Starter
We are using our Off-Road Pro Series control arms for this build just like you could buy off the shelf from us. 7075-T6 Aluminum with Pro Series Krawler Joints at each end. These arms will take a beating for sure. We powder coated them a custom yellow color in house just to match the Jeep.
The extended PSC Crusher Corners are mounted.
The PSC Rocker Knockers are also mounted!
Time to link it up! We should be getting the motor back front the engine builder today too!
RK
The extended PSC Crusher Corners are mounted.
The PSC Rocker Knockers are also mounted!
Time to link it up! We should be getting the motor back front the engine builder today too!
RK
12-09-2013, 07:10 AM
#7
Former Vendor
Thread Starter
Trending Topics
12-09-2013, 04:34 PM
#8
Former Vendor
Join Date: Oct 2012
Location: Newton, NJ
Posts: 1,615
Likes: 0
Received 0 Likes
on
0 Posts
Awesome. I remember seeing this as you were stripping it down. Planning on heading to Rausch for a shake down? Let us know we would love to wheel with you guys.
12-10-2013, 11:05 AM
#9
Former Vendor
Thread Starter
