Mopar Dana 60

[MD_Rubi]

Not sure where to post this but does any one know the part number for the Mopar Dana 60?

[pearl-drum-man]

Yeah, I haven't actually seen it as available yet.

[TxCop07]

Not sure where to post this but does any one know the part number for the Mopar Dana 60?

Are these suppose to be a bolt up part for the Jeep?

[WV99XJ]

As I understand it, it will bolt up but the bolt pattern is 5x5.5 and they dont have a front yet.

[cibach]

they are supposedly made by quadratac

[Ctimrun]

they are supposedly made by quadratac

Actually I think they are Dynatrac spec'd axles, which = $$$$$

[Blue]

The mopar D60 is a rear axle that is "stock" on the J8. The J8s also are leaf sprung rears. When they do come available, they may require a bracket change.

If you have the $$$$ currie has some bolt in front and rear D60s for the JK.

[MD_Rubi]

I contacted both Curry and Dynatrac and they are not cheap. Dynactrac is over $10 for both front and rear but that includes everything. Curry's rear is rather cheap but you have to purchas the lockers and gears. Front of the other hand is over $4k. Sometimes i have noticed people on this forum can get the part number before they are listed by mopar.

[JK GABY]

Check if you can use a Ram 1500/2500 Dana 60

[2K1TJ]

Check if you can use a Ram 1500/2500 Dana 60

Probably too wide, and probably 8 lug, at least the 2500 likely will be. May not be a big deal to some, but most will want to run the same pattern front and rear.