i installed the daystar tray and now my compas is stuck on - -SE .. any ideas thanks Jon jonstillrushin@aol.com

 

Any chance the wires got pinched when you reinstalled the lid?

 

Make sure you didnt install backwards or pinch a wire.

Check your manual on how to calibrate the compass

 

Is anything sitting in the tray?

 

Phones and other devices sitting in the tray will affect your compass. Check the connector... disco it and reconnect it for S&G's.

 

i switched the compass around it can go both ways..lol might still need to be calibrated..thanks everyone

 

I HAVE THE EXACT SAME PROBLEM! mine was stuck on SE for a week or two before i decided to check the manual. i calibrated to i dont know how many times. so there i am in a parking lot driving in circles looking like an idiot still with no luck so its working now but it displays N for S and E for W and so on. i thought about the issue of phones being near it or some kind of electronic device. nodda. so, i have a question, i did install fogs recently and ran the power and load wires up under the dash panel. would that have any affect on it?

 

Check and see if you installed backwards

 

This is 100% dead on...happened to us when we installed it and immediately threw our cell phone on the tray......doesn't the pic on the box show a cell phone in the tray? Anyway once you get it recalibrated remember you can't put phones, iPods, anything magnetic in the tray...sort of sucks cuz ours became purely for sunglasses

 

i feel real dumb. it was backwards i guess i had taken it off when i painted that dash console piece. what an idiot! fixed now. its a-ok