Driving light mount
 

I'm not much of a fabricator or welder, but sometimes I really impress myself.

I purchased some driving lights last night and need a place to mount them with my factory bumper.

I spent abut $7 other than what I already had lying around. I used some left over 1.5" square tube and I purchased a 1.5" piece of 1/8" flat stock.


I first pulled out the trim piece between the grill and the bumper and trimmed off the ends.

Attachment 239092 Attachment 239093



Next I measured the outside distance of the frame rails, cut a piece of square tube, welded on some long legs, that will mount to the frame, and some light tabs on the top. Here is the finished product.

Attachment 239097 Attachment 239098 Attachment 239099

Here are a few shot of it fitted. I have not yet mounted it or painted it, but that will come in the next few days.

Attachment 239101 Attachment 239102 Attachment 239103 Attachment 239104 Attachment 239105

very nice!! didn't know you could fab stuff up :thumbsup:

Thanks. I'm not really much of a fabricator and I don't have all the tools that I would like, but I can weld enough to make metal stick together. This should work fine, for no more stress that the driving lights will cause.

I like it great idea!

looks good. :thumbsup:

Real nice!

Thanks. Here is an update with it painted:

Attachment 239535 Attachment 239536 Attachment 239537 Attachment 239538

I haven't received the lights yet so I still haven't mounted it but this is where I'm at until I get my lights.

Look great. Nice idea.

Love the bar. What lights ya going with?