blend door position when installing actuator
Thread Starter
JK Newbie
Joined: Feb 2025
Posts: 2
Likes: 0
blend door position when installing actuator
after the original rightmost blend door actuator failed, in the glove box by passenger door, I installed the Dorman that lasted couple of weeks. I am about to install a brand new Mopar actuator. I'm going to disconnect the battery during the install so that when I connect the actuator to power before installing it, it doesn't start rotating and get off the factory preset. What position should that white plastic blend door be in when installing it? All the way up, down, middle, or somewhere in between? I wanna get it right this time, as those who've done this project, know that the back screw that's all the way in the front toward firewall is a pain to get to. Thx.
Thread Starter
JK Newbie
Joined: Feb 2025
Posts: 2
Likes: 0
Welcome to the Forum.. Never had to replace; however, this video might enlighten: https://youtu.be/pOiQ4y__rHc