One Ton Axles
For SaleDrivetrain
07-03-2018, 08:31 AM | Replies: 3 | Views: 2548
Description:
Jeep JK One Ton Axles - $6500 (MYR) hide this posting
© craigslist - Map data © OpenStreetMap(google map)I began a project for my 2009 Jeep JK and haven't lost interest but have my attention on other things at this point. So what I have:
2003 GMC 2500 14bolt axle with disk brakes
Stock axle shafts
Artec bracketry welded on. I did not feel the need to weld on the truss however I do have it and it can be welded on.
Artec 52 tooth tone rings pressed on hubs
Artec Speed sensor brackets
ARB RD114 rear locker (with all plumbing and manifolds and switches) will need and air source
G2 5.38 ring and pinion
G2 Master install kit with Timken Bearings
1350 Yoke
Comes complete with calipers and rotors.
All new seals
2002 F350 Dana 60 with axle shafts (30 spline outers)
Artec complete braketry and truss kit installed
ARB RD167 locker (with all plumbing and switches) will need an air source
USA Standard 5.38 ring and pinion
USA Standard master install kit
Warn Premium lockout hubs
Calipers, I do have rotors but probably could be replaced
Passenger side knuckle is machined and fitted with a high steer steering arm.
New ball joints installed (Spicer)
All new seals (Spicer)
Drill guide to convert unit bearings to 8x6.5 bolt pattern
Have the stock tie rod from the F350
I have waited until I drill the unit bearings so I have not installed the new vacuum seals, dust seals and lockout hubs. This is not quite a turnkey set of axles. The parts are there. It will be up to the purchaser to drill the steering arm, unit bearings if desired and put on the final touch. I have a pile of time and money And DO NOT NEED TO SELL but as I said I have my attention on other things. My Jeep has been a never ending project since I got it so I will likely continue the axle project down the road. Any questions feel free to ask. $6500