3.5" Lift
Thread Starter
JK Newbie
Joined: Jun 2011
Posts: 1
Likes: 0
From: Highland Mills, NY
3.5" Lift
Hello, new to the forum and to the Jeep world.. and like most newbies I have ordered a few mods and have a question. I am installing a rustys 3.25" basic kit and will be running 33" tires. With an auto do i need to worry about tearing up the drive shaft boot? with this config? Thanks in advance for the help..
11 Sahara Unlimited
11 Sahara Unlimited
JK Junkie
Joined: Nov 2009
Posts: 2,737
Likes: 1
From: Rochester, NY
According to the FAQ in the modified section... you might have to pay attention to the front shaft. I am not sure about the rear shafts on a 4 door.
Also, 33s are a good tire for no regear, but you will think they are TINY on a 3.5" lift.
Hell... I think my 33s look kind of small with my 2" lift.
Also, 33s are a good tire for no regear, but you will think they are TINY on a 3.5" lift.
Hell... I think my 33s look kind of small with my 2" lift.
JK Enthusiast
Joined: Jul 2007
Posts: 107
Likes: 0
From: Hinesville, GA
Hello, new to the forum and to the Jeep world.. and like most newbies I have ordered a few mods and have a question. I am installing a rustys 3.25" basic kit and will be running 33" tires. With an auto do i need to worry about tearing up the drive shaft boot? with this config? Thanks in advance for the help..
11 Sahara Unlimited
11 Sahara Unlimited
And I do disconnect regularly...
