JK-Forum.com - The top destination for Jeep JK and JL Wrangler news, rumors, and discussion

- Modified JK Tech (https://www.jk-forum.com/forums/modified-jk-tech-2/)

- - Pure Jeep Rockers (https://www.jk-forum.com/forums/modified-jk-tech-2/pure-jeep-rockers-26685/)

Quote:

Originally Posted by RedrockX (Post 528021)

Have any of you done the install with the Shrockworks rails on a 2dr?

i havent recieved mine yet (i should TONIGHT) and wonder if they have to drill as much as the 4drs...?

:thinking:

I had these on my Jeep originally. They are strong, you will like them. As far as drilling goes, I think it is like two holes on each side of the Jeep. Not bad at all.

Quote:

Originally Posted by pulmano1 (Post 527812)

I was searching through your thread and was thinking the same. I am just gonna take it slow and drink some beers after I get the holes drilled.

Make sure you read the instructions all the way through before doing any drilling. One guy didn't use the drilling guide because it was mentioned later in the instructions. The holes are drilled on an upward angle so they come out in the correct place inside the Jeep. Also, just make sure you have the sliders jacked up tight and in the right place before marking the holes. Like putnam dan says, it is a little bit of a challenge but worth the effort in the end.