Rubi 4.10 gears into Dana 30?
05-13-2010, 05:25 PM
#1
JK Enthusiast
Thread Starter
Join Date: Dec 2008
Location: Arab, Alabama
Posts: 285
Likes: 0
Received 0 Likes
on
0 Posts
Rubi 4.10 gears into Dana 30?
Will the 4.10 gears out of the Rubicon Dana 44s fit in the Dana 30 & Dana 44 out of an X?
Before everyone goes nuts... I'm not talking about the carrier, I know they're different spline counts. I have searched the forum and I can't find where anyone has talked about installing just the ring and pinion gear out of a Rubicon axle into a non-Rubicon axle.
Any help would be great.
Before everyone goes nuts... I'm not talking about the carrier, I know they're different spline counts. I have searched the forum and I can't find where anyone has talked about installing just the ring and pinion gear out of a Rubicon axle into a non-Rubicon axle.
Any help would be great.
05-21-2011, 09:50 PM
#3
JK Jedi Master
Join Date: Jan 2008
Location: Austin <--> Colorado Springs
Posts: 11,465
Likes: 0
Received 162 Likes
on
154 Posts
The rear JK rubi 4.10's will fit in the JK non-rubi rear 44
Gears from a Dana44 will NOT fit in a Dana30
Gears from a Dana44 will NOT fit in a Dana30
Last edited by nthinuf; 05-21-2011 at 09:55 PM.
