JK-Forum.com - The top destination for Jeep JK and JL Wrangler news, rumors, and discussion

Notices
Stock JK Tech Bulletin board forum regarding issues with OE (original equipment) components of the Jeep JK Wrangler (Rubicon, Sahara, Unlimited and X) such as factory suspension parts, engine, transmission, body parts, interior fixtures and the on-board computer.

Slave cylinder

Thread Tools
 
Old 05-23-2024, 11:11 AM
  #1  
JK Newbie
Thread Starter
 
Bigbearzach's Avatar
 
Join Date: May 2024
Location: Milton fl
Posts: 3
Likes: 0
Received 1 Like on 1 Post
Default Slave cylinder
So is the slave cylinder a known issue with the 6 speed Jks. I am asking because I have replaced it once and have to do it again. If it is are there any way to make it better and more robust.
Bigbearzach is offline  
Reply Like
Old 05-26-2024, 05:34 AM
  #2  
JK Enthusiast
 
MountainTrails88's Avatar
 
Join Date: Apr 2020
Location: Bellingham, Wa
Posts: 158
Received 10 Likes on 9 Posts
Default
Why did you replace it. And whats it doing now.
MountainTrails88 is offline  
Reply Like
Old 05-26-2024, 06:34 AM
  #3  
JK Newbie
Thread Starter
 
Bigbearzach's Avatar
 
Join Date: May 2024
Location: Milton fl
Posts: 3
Likes: 0
Received 1 Like on 1 Post
Default
It completely stopped engaging the clutch and when I pulled it out it had fluid leak out from around the rod
Bigbearzach is offline  
Reply Like
The following users liked this post:
MountainTrails88 (05-26-2024)
Old 05-26-2024, 07:50 AM
  #4  
JK Enthusiast
 
MountainTrails88's Avatar
 
Join Date: Apr 2020
Location: Bellingham, Wa
Posts: 158
Received 10 Likes on 9 Posts
Default
Never had problems with mine. Other than it vibrates at 2200 rpm and is most likely caused by the throw out bearing.
MountainTrails88 is offline  
Reply Like
Back to Subforum
Stock JK Tech
View Next Unread
Cold Start Engine Rattle




Advanced Search
Quick Reply: Slave cylinder


Reply Closed Thread Share

All times are GMT -8. The time now is 10:48 AM.