I got a code for 02 sensor voltage to high. I just installed the kit. When I wired up the o2 sensor it said wire the black box to the input? to wire from the o2 sensor? So the wire from the engine control unit is left unconnected? I wish I could call ripps!

 

Well from looking at my post its hard ti understand. When running the wire to the black box to the o2 sensor does it go to the sensor side or the ecu side or does it splice in?

 

Only someone who has done this, or has seen the instructions, can help you.

 

I know. Hoping to find a few that have

 

Why not ask the experts? I have asked them a few questions. Very helpful.

RIPP Modifications LLC

Monday - Friday: 9am to 6pm EST
Saturday 9am to 2pm EST
Sunday Closed

Phone: (718) 815-1313

Technical support: tech@rippmods.com

 

I don't have a Supercharger, but from what you're describing, you'd have to splice it in to the proper wire. Cutting the wire and leaving it disconnected will make the computer set a code. HTH.

 

I tried calling them this morning and got a message that they were closed. I just tried them again and got it sorted out. Thanks for the help!