Hello,

I am wondering if anyone has a CAD file of the locating/Mounting hole specifications of a JK? I am going to design/fabricate a front bumper, but haven't had a chance to pull the old one off and get any measurements from it.

I would appreciate anything I could get, I can open pretty much any type of CAD file

Thanks in advance

 

Here is a link to the holes spacing for the front bumper, its what i used when i did my bumper, http://i600.photobucket.com/albums/t...jkbumper-1.jpg

 

I used this also with my bumber build. However my bottom holes where 5" on center not 5.25". There closer. And my plates weren't 24" apart.

 

Thats funny its a perfect match for my 2dr.......

 

Just went out to the garage and measured mine that was laying out there. The bottom studs are 5 1/8" center to center and from inside stud to inside stud it was 25" center to center.

 

Nice link,