I just ordered a Body Armor bumper/tire carrier and says it will support the 5217 can mount. I can't find this anywhere. Is there an easy way to make these? If so what all will I need to do it? I don't have a welder so I am going to need to be able to bolt it together.

Thanks in advance!

 

google is your friend...google this "body armor 5217 can holder" and go to the fifth listing down and click on it....below that you will see a section "you might also be interested in"....and it is there.

 

Yeah, Bing is set up on the work computer. Just found it on page 3 and the part was listed under "Tools" Thanks.

 

$270? that seems a bit pricey doesn't it?

 

What does this thing even look like???

 

I was going to post a link, but probably not a good thing.

Google "body armor 5217". Lots of pictures.