This is my first set of grab handels and I do like them alot.

My question is about the plastic type molding under the roll bar cover. Whenever I grab the handle it kinda spins cause I can not really get it tight enough to get the plastic to stay tight on the roll bar.

Any recommendations to keep it from spinning or is it just something to get use to?

 

Ya it moves, and I never really came up with an answer for it. I sold mine and put on the Rugged Ridge ones that mount in upper corner of windshield area and like them twice as much.

 

You could try double sided 3M tape, or a more permanent solution like glue if it really bugs you.

 

I got a set of the qtec ones and the rugged ridge ones for free. Buddy ordered the rugged ridge side sound bar, and center sound bar but quadratec sent him the qtec front ones and side sound bar ones. Told him keep the qtec front ones and then sent him another set of rugged ridge side sound bar ones and told him to keep those as well.

So I am sure ill deal with it cause they were free. Was just seeing if anyone did anything about this...