Hey guys,

I have a 1310 coast front drive shaft installed on my jk. I was getting ready to grease it this past weekend and noticed that their is a cap loose along the slip joint that is usually secured on the side closest to the axle. Any ideas as to what to do? I was just planning on taking a rubber mallet to it and putting it back into place. Anyone else have an experience with this?

 

A pic would be helpful.

 

im about to purchase coast drive shafts. i spent a lot of time on the phone with Bill the other day and he was very helpful. I would call them in the am and get the answer directly from the horses mouth. Good luck!