Notices
Modified JK Tech Tech related bulletin board forum regarding subjects such as suspension, tires & wheels, steering, bumpers, skid plates, drive train, cages, on-board air and other useful modifications that will help improve the performance and protection of your Jeep JK Wrangler (Rubicon, Sahara, Unlimited and X) on the trail.

PLEASE DO NOT START SHOW & TELL TYPE THREADS IN THIS FORUM

3.6L Unichip and Flux2 Display

Thread Tools
 
Old Jan 27, 2013 | 10:29 AM
  #1  
marshman1987's Avatar
Thread Starter
JK Newbie
 
Joined: Apr 2012
Posts: 29
Likes: 0
From: Olney, MD
Default 3.6L Unichip and Flux2 Display

Has anyone had any experience with this company and this unit?

Links:
http://www.unichip.us/vehicle/vehicl...rangler-JK-36L

http://www.unichip.us/products/46-FLUX-In-Car-Display
Reply
Old Jan 27, 2013 | 10:41 AM
  #2  
Smashboogie 4x4's Avatar
Former Vendor
 
Joined: Oct 2012
Posts: 1,615
Likes: 0
From: Newton, NJ
Default

Haven't used a Unichip on a Jeep but I have on other vehicles.

About ten years ago I tried it and it was terrible. Then about five years ago I was informed that the product came a very long way and was excellent. Was sent away to go school to properly tune these units and then tried it again on two different vehicles and did the dyno tuning. That was a nightmare and then the car would randomly stall. Pretty much the second you put the clutch in the car would stall. Spent months of sending the unit back and forth to be tested and had the same problem every time. Installed a different performance chip and the car was fine.

Customer service was awful and the product didn't make much power. Very disappointing and very frustrating.

Keep in mind this was ten and five years ago. It might be different now.

I just have a very bad taste in my mouth because of all the aggravation I was put through.
Reply




All times are GMT -8. The time now is 09:44 PM.