I am ordering an adams front driveshaft and they need to know the yoke to yoke length before they will build it. Problem is I'm not getting my new axle with the 1310 yoke on it for 3 weeks. I wanted to have the driveshaft here when my axle was ready.

I have a pretty simple setup. 3" lift, teraflex lower arms. I'm getting a custom built Core 44.

My question is does anyone know the difference in length of the stock pinion yoke vs. a 1310 pinion yoke?

Are there different length 1310 yokes?

Since the Core 44 is a bolt in replacement it shouldn't affect length right?

I would like to measure with my current setup, adjust for difference in yoke length and send them the measurement. This should work right?