I am lookiing at cutting my stock flares. I know the rear wheel liners i dont need, but what about the front ? I live in the midwest (WIsconsin) so I road salt and snow is an issue. The jeep is an 07 daily driver, has not seen off road and more than likley wont, if i do might make the sand dunes in MIch or maybe some mud trails up north.

 

i have Crawler Conceptz inner fenders and like them a lot so far, had them for 6 months or so

 

You an easily reuse the front and rear wheel liners. Just cut then a little and use zip ties.

 

Yeah - I ended up preserving most of mine. I drilled a small 1/4" hole and re-used some of the push locks.

There's a vid somewhere showing a good way to keep them. I'll see if I can find it

 

I was able to leave mine in place after cutting the fender. I used a box cutter to cut out the parts that didn't fit and used two zip ties to attach it to the wheel well.

 

Thanks for all the help. I will keep them in then and just trim them so they fit.