Little help needed gents. I put the 4.5" BDS lift on my 08 JKU about 5 years ago. I have noticed over time that it has begun to sag but didn't realize just how much until yesterday when I saw a stock Rubicon sitting next to me that only appeared to ride about 1 inch lower. Could someone out there with a the same lift I have, recently installed do me a favor and measure your loaded front and rear coil spring height so I can just how much im sagging?

 

Measurements are all relative and every truck will be different, even running the same coils.

Your best bet would be to give BDS a shout and let them know what you're experiencing. Hopefully they'll cover you under their "no fine print" warranty. If not, sell your coils to someone who wants a lower lift height and buy some quality coils. You'll find a million threads on "what's the best coil....?", pick a few and make a choice based on the information you read.

Best of luck with BDS, I haven't had to use their warranty.

 

I have the same lift. A couple years ago I had the same problem and they took of it. If I remember correctly you need measure side to side to show the lean. Good luck.

 

Take a measurement from the bottom.of the shock tower to the center of the lower shock mount nut and see what it is.

I have a 4" Evo lift and mine measures 23 5/8" at that point.

See chart below for reference. .





Sent from my SM-N920T using JK-Forum