I have a 48" Hi-Jack. I ordered the roll bar attachment so it sits horizontally across ( http://www.quadratec.com/products/92200_9001.htm )

The accessory part that attaches to the top/point of my jack, not the base, is literally 1" too far. Thus, I cannot bolt my hi jack's top to the steel mounting bracket.

Anyone else have this problem or heard of this problem?

Any solutions?

I'd post pics but I have no camera. Lost while offroading a while back. Go figure.

 

So, are you saying the Hi-lift is too short? Without pics it's kinda hard to get a visual

 

Actually, we can cancel this thread. I'm a typical idiot. I'm that kind of person where I just begin installing before reviewing the instructions. Anyway, turns out quadratec messed up on my order and sold me roll bar mounts for the TJ when I specifically ordered for the JK. Just got off the phone with them and they are sending me the correct set up.

Thank you for reading about my stupidity.

As a side note: Everyone, read the instructions before you do anything!

 

Instructions? We don't need no stinkin instructions.

 

No worries man that's what the forum is all about, helping another wheeler out! Glad you got it all figured out..