Poison Spyder Bolt-Together Trail Cage Kits
#11
Former Member
Thread Starter
Join Date: Jul 2010
Location: Mentone, CA
Posts: 776
Likes: 0
Received 0 Likes
on
0 Posts
#12
Larry just dropped by my desk to remind me that the Spyder JK, which those photos are from, had several different cage versions in it while we were going through a rather lengthy R&D period for these cages. The plastic fascia's on it were kind of beat up and had been trimmed and re-trimmed for a few different cage versions, and therefore ended up not fitting so well on the final design. I'll see if I can get some better photos of it from some other Jeeps where the cage was a fresh install.
Thanks
#13
Former Member
Thread Starter
Join Date: Jul 2010
Location: Mentone, CA
Posts: 776
Likes: 0
Received 0 Likes
on
0 Posts
#15
I'm interested in the c-pillar kit. Can you confirm for me whether the kit is compatible with a Tuffy security deck? I don't care if I have to ditch the little side boxes on the deck, but I'm afraid the c-pillar base and the sides of the security deck may not play nice together. Thanks for your help!
#17
Originally Posted by Sharkey
I'm interested in the c-pillar kit. Can you confirm for me whether the kit is compatible with a Tuffy security deck? I don't care if I have to ditch the little side boxes on the deck, but I'm afraid the c-pillar base and the sides of the security deck may not play nice together. Thanks for your help!
#19
JK Enthusiast
Join Date: Mar 2010
Location: D/FW Texas
Posts: 273
Likes: 0
Received 0 Likes
on
0 Posts
This is a good question, because on the passenger side, that side dash panel is the easiest way to run accessory wiring through the firewall.
#20
JK Freak
It blocks off dash side access completely. Unfortunatly those side caps are one of the last pieces you install, so you would end up having to take out the whole sport cage to open that side. So it might be a good idea to run all of your planned wiring during install of this cage, and then just terminate it until you are ready for it.
Last edited by Blade; 03-12-2012 at 08:01 AM.