RIPP Long Tube Headers - Bang For the Buck (BEST Mod)
 

Check out our Long Tube Headers Flexing their might as one of the best NA mods out there... 180 Rear Wheel HP and 210 Rear Wheel Torque.

Bang for the buck right here!

http://www.youtube.com/watch?v=Nweruqcef5k http://www.rippmods.com/v/vspfiles/p...HDR-7137-2.jpg

http://www.rippmods.com/v/vspfiles/p...38-LTHDR-3.jpg



Product Link

Question Welcome
RIPPTECH

Since you mentioned bang for your buck...... how much are the headers? typical install price?

the link they posted under the vid has a price right under $2k.

d'oh - thanks....

Wait, so for 1/2 the price you can get close to SC numbers on the Dyno?
The 3.8 must be really really restricted from the factory.

I would love to gain that horespower but $2K is crazy for a pair of headers.

Or the header design is that good... these are Dyno Designed and the tune is killer - Proven product with a killer track record... :thumbsup:

RIPPTECH

2k for a set of headers is still damn expensive dyno proven or not. You can pick up proven headers for a viper for a $1k, new mustang 5.0 for $800 and Ferrari 360 Modena for $3k. I would say the price has more to do with the lack of options than it does value.

I have to agree with you on that.

There are a few reasons they cost so much: One, they include 2 cats. Two, you should get them with the Diablo tuner as they work best with Ripp's tune. Three, they are very well put together long tubes, and there was a lot of R&D that went into them. I'm not saying they're not expensive. What I am saying is that they're not a rip-off (no pun intended).