Stubicon

Sounds good to me.

And there's an ongoing debate as to whether there is an easement across his land or not. Until it's settled, doesn't look like we can go to Shoecreek

dalearyous

you know you can rent an excavator for $200 ish a day

JK505

I seriously cannot wait for this day. Stu, let's set a day! I vote may 9/16!

08YELLO-RUBI

Hey everyone! Looks like I have to replace my clockspring again and I'm wondering does anyone know where I can go locally and pickup parts without going to the dealership? I'm located in Virginia beach. I know I can buy them online I wanted to go this route first. Thx for the help

Grimlock

Any of you guys know anywhere in Northern Virginia where I can find CBs and such. My inter webs are failing me for any local businesses - Northern VA willing to drive for good selection and service. Thanks in advance for any help!

Sent from my iPad using JK-Forum

JK505

There's a shop in Manassas that I was at yesterday and can't remember the name of for the life of me. But I remember it was called "auto"-something. If you're on Sudley Rd, turn onto Ball Ford Rd (right off of I-66) and take a right on to New Market Ct, there's two little streets (more like a parking lot than anything) about 100 yards long called Nathan Ct and Gabe Ct. I believe it is on Nathan Ct.

Edit: Found it!

http://www.bing.com/search?q=auto%20...e71e863ee9dda8

They sell CB''s and all sorts of goodies in there, and they'll tune it for you as well.

Grimlock

Thanks much JK505 - I'll hit them up tomorrow! Sent from my iPad using JK-Forum

Went - got exactly what I was looking for and pretty decent selection of antennas - thanks again for the referral!

scout61

So now red cloud is dead, is off-roading in NOVA dead as well?!!! Is it time to buy a Lexus and drive 95 with the sheep?

Jeeprebel1980

Hello My name is Donnie I am finally getting to lift my jeep next weekend I am installing a 4 inch lift with a full set of adjustable control arms and had 2 questions. I was wandering about measurements for the control arms and a good place to get is realigned in the york county area.

JK505

The lift's instructions should have a recommended length for each one. Then checking your driveshaft angles and caster should let fine tune them. I'll grab an article explaining it if you would like. I'm not from that area so hopefully somebody else will know. Congrats on the lift though