duglas

I upgraded my rear axle to a Currie G2 D60 and selling my D44

Gears and shafts have less than 1500 miles on them..
I removed what was needed for D60 install, speed sensor and brakes. Gears never taken offroad and run with only 35" Km2 tires (measure 33.5").. Has factory locker and is in perfect condition, ready to drop in...

Shafts were $600, gears and install was $850..

$1900.. Axle is in Chesapeake VA 23322..

I also have the factory Rubicon driveshaft if needed

I will take pictures of it tomorrow and post them, it is in the bay at my office..

duglas

Wow... no one...????

The superior shafts have a little bind on the spines, Superior says they are under warranty but will be a few weeks.. anyone want the rear with stock shafts? I can sell the superior shafts when they come back...?? $1300??

daspes

I would be interested and i'm right down the street. But money, it's tight ya know.

Best of luck.

fatboy044

How much do you want for stock shafts?

duglas

I am selling it with the stock shafts if the new owner wants.. The Superior Shafts were sent to SA for warranty replacement, but should be back next week...

Baddintentions4u

What spline are the axles? I'm looking for 35 spline rear axles. And how much for the set if they are what I'm looking for?

jeep2007

Is this still for sale?

duglas

Yes it is for sale

duglas

I still have this sitting in my garage if anyone is interested....

Lordumbar

Did u say u had the rear drive shaft also?