Custom made 1310 drive shafts, front and rear
06-16-2017, 04:15 PM
#1
JK Enthusiast
Thread Starter
Join Date: Sep 2011
Location: Dallas, TX
Posts: 227
Likes: 0
Received 0 Likes
on
0 Posts
Custom made 1310 drive shafts (front and rear), Teraflex Front Brake kit
Hi, as part of a new upgrade to long arms and coilovers I upgraded to 1350 drive shafts so I have my older 1310 drive shafts available. They were bought in Texas from Screaming Lizard Customs but I'm not certain who the mfg is. I've had them on the Jeep for about 4.5 years and replaced the rear ujoint about 2 years ago, the rest have been fine but you'll want to consider new ones I'm sure just to be safe. I have all the parts that came off during the upgrade but only took pictures of the drive shafts themselves. Not looking to ship them, located in Orange County. Asking $100 for both front and rear.
The Teraflex Front Big Brake Kit with slotted rotors is about 4 years old now. Asking $100.
Crown brake line extensions for all 4 corners, have been on the Jeep for about 3 years. One of the lines has the plastic covering worn through in one spot due to tire rubbing before I noticed it, the steel braiding is fine. Asking $SOLD.
I also have a bunch of suspension parts available in that part of the forums if interested.
The Teraflex Front Big Brake Kit with slotted rotors is about 4 years old now. Asking $100.
Crown brake line extensions for all 4 corners, have been on the Jeep for about 3 years. One of the lines has the plastic covering worn through in one spot due to tire rubbing before I noticed it, the steel braiding is fine. Asking $SOLD.
I also have a bunch of suspension parts available in that part of the forums if interested.
Last edited by Infinutty; 06-22-2017 at 08:30 AM.
06-19-2017, 11:00 AM
#2
JK Enthusiast
Thread Starter
Join Date: Sep 2011
Location: Dallas, TX
Posts: 227
Likes: 0
Received 0 Likes
on
0 Posts
Looking to get rid of these pretty quick since I'm moving and would rather someone get them instead of the dump. Make me an offer if you are interested! I do have a box that the driveshafts are sitting in now but not sure how much shipping would be, send me a PM with your address if you want a quote. The brake lines should fit into a flat rate envelope I suspect so could go that route for those. Rotors and brake parts though I have no box for so would be tough to ship in next few days.
