I have a stock 430 UConnect radio. I added a PAC to give me 4 channel RCA outs. I then installed subs and an amp in the back using the rear channel RCAs to run the amp while leaving the components stock. After a few weeks I decided to add a JL 4 channel amp to the main components and instead of running all new wires to the speakers I cut the speaker lines for all four spearers (Yes I know there are eight with the tweets) from the factory harness and connected then to the outs on the amp. The sound is great but since then I have no telephone nor voice commands. I thought the system automatically would go through the PAC amp line. I don't have the upgrade audio with the factory amp so I ran my own. I have checked to make sure no other wires were cut to the Connect module. They are fully in tact. I can't figure this out to save my life and I am no stranger to installing huge and complicated sound systems. HELP!!!