I've put some under-the-dash LED lights in my jeep. I didn't put them under the dash, rather I put them on the roll bar to light up the whole interior. Right now they're just hanging there. I'd like to make them look built in. I've though of putting them inside the roll bar fabric and seeing if I could somehow cut the fabric so the lights would still shine out. I really want to avoid the ghetto look too. I was kind of shooting In the dark hoping someone could offer some insight?

 

This is what the lights do

 

Another picture

 

It is a little too late -- Ghetto it is.

just kidding -- to each his own.

Those things sure are bright.... bet they complement the color of your jeep well.

Sincerely, good luck with this -- if I had ANY idea I would give it to ya.

 

I put mine on the dash pointing down. Lights up enough so I can see stuff.

 

Got them done, have a picture of them on and off. Got them on the passenger and drivers sides front and back

 

Mine are under the dash and rear seats. Plus one on the top of the tailgate pointed in, and one on the bottom of the tailgate that lights up the ground when the tailgate is opened. I don't currently have pics but could post some if you're interested. I'm looking into getting some matching LED's up top as well. But I'm wanting to avoid the "ricer" look. So I'm still deciding on how I want to do it.

Sent from my iPhone using JK-Forum

 

That is the first one I've seen done like that - I like it! very clean installation

 

Got another set put in, I've decided to call it the red light district lol

 

How did you wire them? Please help. I bought a strip of green but can't figure out how to wire. I want them to come on with the dash lights and dim with them too. Please help!!!