BEAST - Building a 6.1 Hemi Powered JKU on 43's
#651
JK Junkie
Thread Starter
Join Date: Nov 2010
Location: Valencia, CA
Posts: 2,942
Likes: 0
Received 0 Likes
on
0 Posts
Just confirmed with Jim Cox at the HigherGround Fab shop that they will have an outside booth/display at the Off-road Expo in Pomona on Oct. 4th and 5th. They are going to have Beast in the booth along with a sick TJ build they recently finished. Always a good time at this show, just make sure to leave your wallet at home!
#652
JK Jedi
Just confirmed with Jim Cox at the HigherGround Fab shop that they will have an outside booth/display at the Off-road Expo in Pomona on Oct. 4th and 5th. They are going to have Beast in the booth along with a sick TJ build they recently finished. Always a good time at this show, just make sure to leave your wallet at home!
#655
JK Junkie
Thread Starter
Join Date: Nov 2010
Location: Valencia, CA
Posts: 2,942
Likes: 0
Received 0 Likes
on
0 Posts
Relocated the coilovers remote reservoirs to get them out of the engine compartment. Jim says they look like missile launchers...
#657
JK Junkie
Thread Starter
Join Date: Nov 2010
Location: Valencia, CA
Posts: 2,942
Likes: 0
Received 0 Likes
on
0 Posts
You know, when I started this build, that was the only initial direction I gave the builder, Jim Cox at HigherGround Fab...I said, "I want shocks so stupid big that you have to cut holes in the hood."
#659
JK Junkie
Thread Starter
Join Date: Nov 2010
Location: Valencia, CA
Posts: 2,942
Likes: 0
Received 0 Likes
on
0 Posts
The HGFab crew started work today on the rear fender storage boxes - these will be very useful for Beast's chasing/recovery duties. As they will be cutting out what's left of the rear quarter panels, they need to reinforce the body in front and behind the boxes:
#660
JK Junkie
Thread Starter
Join Date: Nov 2010
Location: Valencia, CA
Posts: 2,942
Likes: 0
Received 0 Likes
on
0 Posts
This is what the rear fender storage boxes will look like. They are 24" wide x 14" high x 12" deep. The doors will open out and down and serve as platforms for whatever (work table, etc.). HGFab will be mounting the Premier Power Welder and air hose connections inside the rear passenger side box.