Big O Mango Tango at SLC
Thread Starter
Sponsoring Vendor
Joined: May 2007
Posts: 1,646
Likes: 0
From: Bedford, Texas
We have been very busy
with builds; helping customers get ready for Jeep Jamboree's and Moab.Been working hard on getting Jeep's out the door and it has cut into posting time, but I could not let this AWESOME build go without ya'll seeing it
Sean
JK Super Freak
Joined: Sep 2009
Posts: 1,527
Likes: 0
From: USA
Axle width
I'm interested in what is being done to even the front and rear Pro Rock axle width differences. Custom cut rear tubes with axles? Running wheel Spacers on the front? 1 ton knuckles and manual locking hubs up front? Sure is going to be a nice build on this JK
Thread Starter
Sponsoring Vendor
Joined: May 2007
Posts: 1,646
Likes: 0
From: Bedford, Texas
You guys picked up the wrong mango tango, you were supposed to grab mine. Its an easy fix, just drop that one off and come pick mine up. My address is as follows:
Karl ..................
...................................
Chesapeake, va 23322
Call if you have any questions.
Karl ..................
...................................
Chesapeake, va 23322
Call if you have any questions.
Thread Starter
Sponsoring Vendor
Joined: May 2007
Posts: 1,646
Likes: 0
From: Bedford, Texas
Thread Starter
Sponsoring Vendor
Joined: May 2007
Posts: 1,646
Likes: 0
From: Bedford, Texas
No wheel spacers needed because the we ordered the wheels with 4" backspacing.
Front axle in the Pro Rock 44 HD (1/2 wall tubes) and you transfer over the factory knuckles; hub; brakes to keep cost down.
JK Super Freak
Joined: Sep 2009
Posts: 1,527
Likes: 0
From: USA
Dynatrac now has the JK width, front and rear, and the 5 on 5 bolt pattern
No wheel spacers needed because the we ordered the wheels with 4" backspacing.
Front axle in the Pro Rock 44 HD (1/2 wall tubes) and you transfer over the factory knuckles; hub; brakes to keep cost down.
No wheel spacers needed because the we ordered the wheels with 4" backspacing.
Front axle in the Pro Rock 44 HD (1/2 wall tubes) and you transfer over the factory knuckles; hub; brakes to keep cost down.
