Chopped Smittybilt with Superwinch LP8500
#1
JK Junkie
Thread Starter
Join Date: Oct 2008
Location: North Texas
Posts: 2,060
Likes: 0
Received 0 Likes
on
0 Posts
Chopped Smittybilt with Superwinch LP8500
I just had to do it the tubes on the smittybilt src just didnt fly with me the base is great so I just hacked the tubes welded and patched the holes and refinshed it with herculiner. Went down to Northern tool to get a new vice and came across the superwinch for $399 there was no way it was staying on the shelf
Last edited by NTXJK; 03-21-2009 at 05:56 PM.
#2
JK Enthusiast
Join Date: May 2007
Location: Essex, MD
Posts: 267
Likes: 0
Received 0 Likes
on
0 Posts
Bumper looks good.
The Superwinch LP8500 is a great winch for the price. Used it for the first time last week and pulled a 2 door JK and a full size Chevy out of a mud hole...didn't break a sweat.
The Superwinch LP8500 is a great winch for the price. Used it for the first time last week and pulled a 2 door JK and a full size Chevy out of a mud hole...didn't break a sweat.
#5
JK Junkie
Thread Starter
Join Date: Oct 2008
Location: North Texas
Posts: 2,060
Likes: 0
Received 0 Likes
on
0 Posts
It was between the Champion, Smittybilt, I went with the superwinch it looked like better quality and has nothing but good feedback, and emetal as soon as I can find a bender its on
#6
Looks great! I have been thinking of doing the same, this might have just pushed me over the edge, much better to actually see it, than looking at my bad photoshop...
eMETAL, do you have any pics from the side? Just curious how it looks with the holes not being plugged...
.
.
Trending Topics
#9
JK Junkie
Thread Starter
Join Date: Oct 2008
Location: North Texas
Posts: 2,060
Likes: 0
Received 0 Likes
on
0 Posts