Hanson stubby bumper with fogs and Expedition One Rubi skid plate!
04-18-2008, 10:05 PM
#1
JK Super Freak
Thread Starter
Join Date: Jun 2007
Location: SoCal
Posts: 1,558
Likes: 0
Received 0 Likes
on
0 Posts
Expedition One Rubi skid plate!
I installed my Hanson front stubby with fogs and winch hoop a while back but have not had any time to show it off at all. Tonight I installed my Expedition One Rubi skid plate and it turned out great! Looks much better than the unsightly stock bash bar. Installation was very straightforward and I would even go so far to say it was easy, even by myself. I only took a couple pictures but will post more tomorrow when I get better pictures in the sun.
Before with only Hanson bumper....
After with the Expedition One Rubi skid....
Before with only Hanson bumper....
After with the Expedition One Rubi skid....
Last edited by Ctimrun; 04-18-2008 at 10:33 PM.
04-19-2008, 10:36 AM
#6
JK Super Freak
Thread Starter
Join Date: Jun 2007
Location: SoCal
Posts: 1,558
Likes: 0
Received 0 Likes
on
0 Posts
This should have been the way the Jeeps were made from the factory. Even if you don't have a Rubicon you could benefit from this skid kit, as you could cut off that bash bar and clean it up with the skid plate. You would gain probably 3" to 4" of clearance!
