Homemade show off
#81
JK Newbie
Join Date: Feb 2014
Location: Traverse City, Michigan
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
Fuel cell Full custom suspension with out outboard 14" coilovers, three link front, and double triangulated four link rear. 6" stretch, 3" lift, 6" up travel and 8" down. Full roll cage Transfer case e brake setup Tons more on it too like skid plates, bumper and Tire carrier, switch panels, speaker pods, suck down winch, tramp stamp, etc...
#84
JK Enthusiast
Join Date: Aug 2011
Location: Blandon, PA
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
Diamond plate is from the steel mill I work at...first time we ran it, I had our lab guy save me a pc of the scrap. Thought be nice to have a pc from the first run of this stuff and I helped make it! It gets used all the time during camping season, and when I hit the beer fridge in the garage.
#85
JK Super Freak
#86
JK Enthusiast
Join Date: Aug 2011
Location: Chardon, OH
Posts: 365
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the comments guys.
#87
Ringer quit your job and start making all those things you listed. I bet you would make a ton just form those super BADA$$ half doors. I got a chubby just lookin at em. I am forever jealous of your fabricating ability and creativity. RESPECT
#88
JK Freak
Join Date: Sep 2012
Location: huntington beach CA
Posts: 844
Likes: 0
Received 0 Likes
on
0 Posts
All in one, Spare, Hi Lift, Rack
This is one of my favorite things on my jeep. 90% designed by me, but to be honest the tire rack was built by a friend with the welder and pipe bender. and the Jack and basket were built by both of us in his garage. I can remove the entire system from the back and put in my rear seat in about 15 min! After I took the spare off the back bumper,, we added the Rotopax to the rear swing arm.
Last edited by big dr; 02-04-2015 at 12:07 PM.