I'd like to get one made from one of these small plasma globes....




You'd think someone would have made them, but I looked and looked... nothing.

It would have to be really thick glass or encased in acrylic/lucite so it wouldnt break.

 

I bought a cheap shift knob for my 2007 wrangler 4 door. basicly I have no idea if it will work. The package says its for manual transmissions which I have , it also says it fits a shifter stem from 5/16" to 9/16" and has adaptors Included (will I need those)
I pretty much need a full tutorial on how to take my factory knob off and install this cheap knob I got from wal mart made by "auto drive"
Will this knob install without rattling and being loose???

thanx

 

I have the same one! I got another shifter from a wrecked jk, and hit the old knob off with a hammer and just epoxy-ed the skull knob on... If I didn't like it I could easily swap back just in case

 

i have it on and tight! i like that gear knob i think the lime green skull with the under bite is awesome! I used a slap wrench t loosen the factory shifter enuff to yank it off.( does work better in 2nd gear) to put it on i used epoxy and tighten the knob with the screws it came with. Shifter cost 13 bux! thanx for everyone help in previous posts.

 

Got these to match my Rescue Green Rubicon🇺🇸

 

That is awesome. I have the same setup. Where did you get them?

 

good ol Ebay actually, i definitely wanted to change the stock shifters just for something different/classic looking

 

where did you get this bad boy? I'd like to have something like this on my '16 auto shifter.

 

So still no T handle type shift knob for manuals that I can find. Looking for something like the Hurst or B & M.