Replaced my pass front axle, welded my trak bar relocation bracket, and found out my bolts on the lower control arms were pretty loose.

 

Was it a easy kit? Anything that you would suggest to someone about to get one?
About how long it take to put on?

 

Had Screamin' Lizard do some 5:13 Gears, C-Gussets and an Alignment. I also had them do my AEV snorkel kit since I was being lazy and still came in $600 UNDER Budget.

I can't say enough about Sean and his crew at SLC, well worth the 170 mile drive.

 

Decals....I love them. You may hate them, but I love them!

 

RC 2.5" coil lift, 2.2 RC performance shocks installed, with 1" Teraflex spacer both front and rear

 

Normally I'd post mods here. But...what I did to my jk yesterday was...run winch cable from a buddies propane powered truck thru 3 trees with snatch blocks then down to my jeep with a snatch block on it and still couldn't get unstuck! :-)

 

not my JK though, sorry but I wana share the experience.

 

Just got done re-painting the freedom top panels black. Both outside and in. Im gonna have to get more spray paint to do the back. No more scratches and white spots showing though!

 

I have stopped worrying about what other dudes think about my "mini-mods". You have to go with you gut because ultimately you are the one who gets to enjoy every little tweak. I think you have to try pretty hard to make a JK look bad - although it is NOT impossible

I had my local decal shop make 1000 bolt decals and plastered them all over my rig. I think it looks awesome (like rivets) but it's not for everyone.

Any more decals in your future?

 

PSC Brawler Lite with brawler bar and Warn 9.5 TI