TURTLECON

How'd it go? What did u wire the switches to operate? I've got mine but can't install until Saturday.

Orangeav

It went great! I was planning on doing a write-up but the RR install instructions are so clear there was no need. I had to do some extra trimming on the cut-outs to fit the switches but I'd rather need to trim some more than otherwise. I'm running my windshield Hellas and Bumper mounted Hellas right now. I have 2 more switches for when the time comes. I thinking either rock lights or rear mounted lights. Overall the color match is great on my '07 and fit seems pretty good. I might do some tweaking b/c the door seems to make contact with it when I close the door and pushes it in a little.

Update! Rugged Ridge continues to be Awesome! I got a PM from them explaining the trimming procedure for a perfect fit avoiding contact with the door. This was un-prompted and I was by no means dissatisfied with this part. Just showing me again what truly great customer service is! Thanks RR!!!

familystylejeepin

ok- truth be told, i just couldnt see over them when making a right turn...hence i decided to put my Snorkel there instead!

Finished Product...

silverbear

I bought one! 08 X bone stock. Getting set of pro comp 6001 and 305 xtreme a/t next week. Also want to get some KCs by the windshield.

It will be the family convertible for me, my wife and three boys to take on the beach and do some light trails.

Oh, how do I remove the X to add the JK sticker?

dgnr8

Just peel - you can rub a corner till you get underneath the sticker, or use a hair dryer to loosen the sticker.

dcirate25

Added running boards finally!!!

silverbear

Thanks! So simple even a silverbear can do it!

familystylejeepin

after you heat it up with a hair dryer, use a small amount of nail polish remover on a cutip to remove the glue residue. you only need a drop! then wipe it off quickly with soap and water. if you leave it on, it will fade your paint.

briaros6

Replaced my windshield (numero 4 now), installed my new Teraflex disco's, and will be taking it out tomorrow to see the new flex with the new 35's I had put on last friday!

GON WHLN

Ordering my PSC Rock Brawler lite today to replace my bent POS Chinese bumper. Waiting for 2 center caps to replace my destroyed ones, going to install SS rear brake lines to match the front. Waiting for my Jeepswag SS relocation braket and Bilstein stabilizer.

Still trying to figure what the F#$% is going on with my steering wheel kick back and trying to seat my rear springs better so they don't pop anymore.