What was done to your JK this week?
JK Jedi
Joined: Oct 2010
Posts: 5,192
Likes: 3
From: REDONDO BEACH, CA
Originally Posted by big c
Like it could u put up more pics if it
Also, I bought the wind deflector from a guy on the forum. Next step is to mount 4 offroad lights on the top & possible 2 more on the rear.
JK Newbie
Joined: Oct 2011
Posts: 40
Likes: 0
From: Baltimore, MD
I did it on my previous JK Sahara...
The screws on the bottom can be removed, but there are six or so across the top that require the bumper be removed if you want to preserve the screws. I had no intention of putting mine back on so I just pulled the silver trim off, popping it off the screws and leaving the screws behind the bumper intact.
The screws on the bottom can be removed, but there are six or so across the top that require the bumper be removed if you want to preserve the screws. I had no intention of putting mine back on so I just pulled the silver trim off, popping it off the screws and leaving the screws behind the bumper intact.
I did remove it. All that's holding on the bumper are 6 bolts... 2 at each corner, and 2 near the center. It's pretty easy to take off/on. Then there's just 10-12 small torx screws holding the silver overlay on. Came off easy. Took some cleaning solution and cleaned all the grime off it real good & remounted bumper.
JK Super Freak
Joined: May 2011
Posts: 1,000
Likes: 0
From: North County San Diego, California
...how is the light output? If you had the choice again would you buy those over HIDs?
JK Super Freak
Joined: Mar 2009
Posts: 1,739
Likes: 0
From: Long Island NY
Real happy with the IPF's. Clean flat cut-off on the left side with a sharp eye-brow on the right side away from traffic. Remind me of my old e-code Xenon's. Super bright. Install was plug and play. I opted to have the headlight bezel powder coated while they were apart.
JK Freak
Joined: Sep 2011
Posts: 835
Likes: 0
From: Casper, WY
aFe intake installed, woods stabilizer bracket installed, marker light mod modded!
A total of about 25 minutes of work for a lot of change!
The aFe makes the Jeep growl and like everyone else has said WTF were the engineers thinking not wiring the lights this way in the first place!?
I would like one of your silver bumper plates if you don't want much for it...
A total of about 25 minutes of work for a lot of change!
The aFe makes the Jeep growl and like everyone else has said WTF were the engineers thinking not wiring the lights this way in the first place!?
I would like one of your silver bumper plates if you don't want much for it...
JK Freak
Joined: Jan 2009
Posts: 697
Likes: 0
From: Leonard, MI
got her ready for a long MI winter. Needed serious bath after this weekend's wheeling, soft doors and Trektop NX removed cleaned and packed away, vacuum inside and scrub out mud. Removed all stickies from rocker and hit rocker with rattle can flat black to hide rock rash. Finally got hardtop and hard doors on so I can stay warm a cozy until spring. 
after and before !
after and before !
JK Newbie
Joined: Oct 2011
Posts: 40
Likes: 0
From: Baltimore, MD
Originally Posted by CottonFire
I would like one of your silver bumper plates if you don't want much for it...
