What kind did u buy? Looks good!

 

Introduced my rig to the beach...yup!

 

Hard wired my warn compressor straight to the battery. Tomorrow (when stores open), I'll get the hardware needed to mount it. It's going to be mounted on the floor next to rear passenger seat; still allowing seat to fold down..

 

I bought the Walmart Platinum Burners. just followed WOL's write up probably took a helluva lot longer than it should but when I went to "borrow" a couple connectors from my neighbor who happens to be an industrial lighting engineer, we ended up rewiring everything but does look good

 

i haven't done a thing, poor thing is miserable in my garage. She needs a oil change and her cb fixed (which is being a pain in my A$$)

 

Installed my ACE hi-lift mount and jack! I dig it.

 

Changed out my ball joints last night. Those uppers are a b*tch!! Took me about 5 hours total. Im glad I did them myself though. I understand why shops charge so much to change them.

 

Helped a friend do his then got curious about how much the local dealership would have charged.

$560

.

.

.

. . . for each side!!! Yup, a total of $1120.

He has about $200 in his, plus he now owns the press set.

 

Lucky! I'm going to attempt the same myself. I've got a minor shimmy in the steering at 45-50mph and it has to be my ball joints. Haven't had the time to check but ive been doing my research.

 

Just cleaned my engine bay with engine foam and cleaned my AEM dry flow filter and pre filter. Next weekend is plugs, wires, tire rotate and oil change. Oh! And sea foam and carb cleaning. It's going to be a long weekend lol.