Procal update for tire size and tpms. Also installed cobra 75 wxst, and 4ft firestick with spring and quick release mounts. And installed the warrior products hawse fairlead license plate holder. Today I'll be tuning the cb setup as well as doing some metal cutting on my Smitty xrc sliders (with my new dewalt angle grinder) so they quite rubbing. And hopefully i can replace the front trackbar bolts with the properly sized bolts. Busy busy before the new year! Happy New Year everyone!

 

It's amazing how something like that can help. Heard it even extends the life of the starter when the battery stays fresh.

 

Finished 2011 with my stubby bumper conversion with fog lights. Now just have to wait for shackle mounts,winch plate and winch to arrive.

 

Looks good. Did you cut the ends or cut/bend them inward. That's one of the beat jobs I've seen! Nice work!

 

And where and how are u going to mount shackles?

 

Just finished sanding and first 3 prep coats on my vent rings. I will finish putting the final coats on tomorrow and re install. I also plan on doing a write up once it's all done. Ive seen people do this, but haven't found a write up.



I will post final pics Tom and a link to the write up if anyone is interested!

 

Blacked out orange reflectors on ARB bumper - chose not to have them wired up - don't need them and it looks better IMO.

 

I finally got around to installing my D-rings and mag lite holder. I tell you I thought I would never get the job finished!!!!!! I put some rubber bushings on the D-rings to keep them from rattling. Happy New Year to everyone a little early!! Keep those mods coming. My New Year resolution is gonna be somewhere along the lines of a trip to Moab and more Mods this upcoming year!!!!

 

Trektop NX, 17x9 addicts, stock rubi tires, Daystar upper dash panel installed this week...

 

I got hung up on a rock wheeling today.
Didn't realize I was spinning on the rear driveshaft till it was too late.
Now it's time for a Tom Woods shaft to match the front.