Synergy ball joints & RCV up front

 

Added Zipper Pulls


Using this site:
Cobra Knot | How to tie the Cobra Knot (Solomon Bar or Portuguese Sinnet) | Decorative Knots

 

No I have the rancho 2" sport lift which only came with front springs and a spacer in the rear. With the 35" toyo on the back the rear sagged, so I added a teraflex coil to lift the rear up a bit.

 

removed the RUBICON sticker and replaced with....

 

Wich tf springs did you go with? I've got the same lift and may need to do the same thing when I put my tirr carrier on.

 

I used the 3" rear coil, because when my lift was installed my front end was jacked up so much that they had to add an 11/2" spacer to the rear to level it off. If yours set right I would just do the 2" coil.

 

Added the Rough Country dual steering stabilizer but was only able to use one side for now due to my aftermarket RE drag link. If I take the drop pitman arm off I can get it on there but that will increase the Bump Steer as well so damn the bad luck on that one but I will figure it out before I give up.

 

Hard top off, soft top on. Now ready for some warmer weather.

 

Added my 48" Extreme Hi-Lift jack to the hood with the Warrior hood mounts. Also installed some Vled 3157 reverse lights. Nice and bright!

 

What a great color of Jeep.