I was out of town last week. When I got home today David from alpha expeditions left me some gifts! The list of items are: extension rack for my Gobi, upper rear stabilizer for roof rack, trash-a-roo, AND stickers




Thanks David! Now I need some green Gerry cans to match my trasharoo.

 

Added the Jeep door Sills, and a Cool Tech Mount for the Cobra CB Mic.

 

Uniden Radio and 4' Firestick.

 

Everything working great! Hooked the Mopar harness to the bottom connector on the tail light and left and right sides work perfect.

Here is the brake controller I put it. A Tekonsha P3. Fits well and is the best on the market with a digital accelerometer instead of a pendulum. Got it installed in a great place where it isn't in the way, I can see it and I can activate the manual brakes if need be.

 

Installed Synergy tie rod.

 

Was it a difficult install? What did you use a pickle fork?

 

I took it to Globex Performance, a jeep specialty shop here in NJ. Watching them do it looks easy to install, but then you have to do an alignment afterwards.

No pickle fork...a hammer and an impact gun to take the nuts off. They also took the wheels off for easy access.

 

Did a grill mod then grilled some chops!!

 

I did two things today.

1. Hooked up some quick disconnects for my CB. I have a small Cobra radio and a buddy has a much nicer Cobra. These disco's will allow us to swap radios when needed.

2. I'm almost embarrassed to say this one. I've had my jeep for a little over two years and I just now took the doors off. Wife was skeptical but changed her tune when we went for a drive.

 

Installed some TeraFlex quick discos. Like many I've seen here, I had to grind down the round tube cross member in the frame to get the sway bar to swing up.

Sent via Jeep wave from my NSA-approved domestic espionage device