What was done to your JK this week?
JK Enthusiast




Joined: May 2015
Posts: 236
Likes: 21
From: up in the woods, on the back side of a mountain
Ok, so I installed my ACE Halfback rear bumper.
I did not get the led light cut out's, but got the cutout for the factory hitch for future installation.
The bumper came packaged extremely well with no damage.
It took all of 1/2 hour to install. Had to drill one 1/2" hole.
Fit fine with my Tactik hinge tire carrier and 315/70-17 ST MAXX, so I'm assuming it will fit with TF/Smittybilt and RR hinges.
Thanks AJ@Ace Engineering for a great product built in the USA!






I did not get the led light cut out's, but got the cutout for the factory hitch for future installation.
The bumper came packaged extremely well with no damage.
It took all of 1/2 hour to install. Had to drill one 1/2" hole.
Fit fine with my Tactik hinge tire carrier and 315/70-17 ST MAXX, so I'm assuming it will fit with TF/Smittybilt and RR hinges.
Thanks AJ@Ace Engineering for a great product built in the USA!






That looks awesome, did you move your front axle forward some?




