JK-Forum.com - The top destination for Jeep JK and JL Wrangler news, rumors, and discussion

Notices
JK Talk General discussion forum regarding thoughts, opinions and rumors about the Jeep JK Wrangler or related subjects that don't quite fit in the Modified, Stock or Electronics forums.

Axle Question!

Thread Tools
 
Old Apr 8, 2015 | 09:15 AM
Share
  #1  
Jkmatt14's Avatar
Jkmatt14
Thread Starter
JK Newbie
 
Joined: May 2014
Posts: 9
Likes: 0
From: San Lorenzo, CA
Default Axle Question!
What is the difference between a unit bearing axle and a full float axle? Looking at the Tera60 axles front and rear! Thanks
Reply
0
Old Apr 8, 2015 | 09:44 AM
Share
  #2  
Maertz's Avatar
Maertz
JK Jedi
 
Joined: Apr 2011
Posts: 4,482
Likes: 2
From: Neenah, Wisconsin
Default
In a semi float the axle shafts see the weight of the vehicle for say and in a full float they do not. Wont bend flanges on axle shafts. IMO if going d60 rear don't get semi float and waste your money.
Reply
0
Old Apr 8, 2015 | 10:33 AM
Share
  #3  
TOTL Innovations's Avatar
TOTL Innovations
Former Vendor
 
Joined: Apr 2013
Posts: 740
Likes: 1
From: Colorado
Default
A unit bearing axle only refers to the front axle. Full vs semi float only refers to rear axle configurations and as mentioned, I would go with a full float as well.
Reply
0
Back to Subforum
JK Talk
View Next Unread
Engine Mount vs Under the Passenger Seat:ARB Twin Air Compressor




Advanced Search

All times are GMT -8. The time now is 11:28 AM.