Anyone have any ideas on strapping down the jack stand in the back of the jeep. Its fully extended but still seems to clunk against the frame when going over bumps? I dont wanna take it out of my Jeep just want to prevent the noise. Thanks!

 

Stuff a towel in there.... Always nice to have a spare towel/rag anyways...

 

That is what I did even though I didn't have the rattle.

 

It might not be the jack. It might be the dreaded door clunk where the gate moves slightly up and down over bumps. I don't remeber where the post was around here but someone fixed it by putting electrical tape around the silver beer bottle opener thingy the gate locks onto. (Sorry I have no idea what the part is called)

 

Here it is:

https://www.jk-forum.com/forums/show...ght=door+clunk

 

Thanks guys when I get home Ill stuff it with the towel. I know its not the latch on the back cause I already put electrical tape around the beer opener! Thanks again guys. Ill let you know when I stuff it.

 

I found that if you spin the jack mechanism so the sides go out a bit it will snug up tightly. Found this out the hard way the first time I tried to remove the jack.