Just returned from a trip today. While on the trail, I noticed the abs and traction control started kicking in while in 4 low. This continued even after turning the traction control off and going into 2 wheel drive.

I have a AEV procal, so I set it back to factory settings and disconnected my battery for several minutes. The issue still persists immediately after starting the jeep. For a few minutes, ABS engages and the ABS, bas, traction control lights are still all on.

You can see my mods listed below. I have done a TON of trails in the past and never had this issue before, I crawled around extensively and can see nothing wrong.

I have searched and the best answer I can find is it may be a bad wheel speed sensor? I can't seem to find a picture of one to know exactly what I'm looking for. Wondering if I hit one on a rock? If there is no obvious damage to any of the wheel speed sensors, is the dealer my only answer?


Any ideas would be greatly appreciated! Thanks