... asked, but is there a need for different drive shafts if I rin 5in. lift w 37's?!

Thanks,

N8!

 

Not sure what Apologees or rin is, but yes.

 

When I installed my Fabtech 3" with 33s, they highly recomended a stronger drive shaft. I havent seen an aftermarket yet....

 

J.E.Reel has them.

 

JE Reel, Tom Woods or HAD (High Angle Driveline)

 

great thanks guys. Started the post with an apology due to not trying to be redundant and thinking someone has been asking this question for a bit.

N8!

 

Hey Zach, Im in kennesaw, Ga. Let me know if you know of any decent trails (moderate) once my Jeep is done. I was going to race at Barbers in Aug., but now have a race in Germany that weekend.

WOuld be cool to get some JK'ers together sometime.

N8!

 

yup. JE Reels where I ordered mine from.

If you have a 2 door, I'm betting you'll need them with a 3" or higher lift, that pinion angles very steep. Mine just went bad after about 7,000 miles on the lift.

 

Are you replacing front and back shafts?

 

yeah, the front seems ok.....but Its steep like the rear. I plan on going to a 4" kit with 37's.. I went with the 1350 heavy duty replacements.