Hi ya'all:

Haven't posted in quite a while, too much work!

Just installed my rear ARBs, and they will not disengage. They seem to let out most of the air, but in order to get all the air out and disengage, I need to go to the compressor and slightly disconnect the line from the solenoid. Then, they will air out in one second and disengage.

Any tips on what I may have done wrong? Maybe a faulty solenoid?

Thanks!!!

 

My guess would be the solenoid valve.

 

There was a thread about this a while back.. May sound funny, but the solution was doing figure 8's and if I remember correctly, do them in reverse as well...

 

Thanks for the replies. Before posting I did a search and could not find anything here, will try again!